Archive for the 'Cooling System' Category
The cooling system keeps our engine from overheating while you are driving around Bowie Maryland. Its job is to move heat away from the engine. Let’s talk about the various components of the system and how they work to accomplish this.
The radiator is the part most everyone associates with the cooling system. Coolant flows through the radiator which has fine cooling fins that draw the heat out of the coolant and dissipate it into the air. To make sure there’s enough airflow over the radiator, a fan pulls air over the cooling fins even when the car is idling.
In some vehicles, the fan is powered by the serpentine belt. On others, an electric motor runs the fan. Electric fans turn on and off as needed. You may have heard the fan kick on shortly after you turn your car off. The sensor has determined that the engine needs a little help cooling down to a safe temperature.
A hose connects the radiator to the water pump. The water pump pushes the water into the engine block. Now the engine block and cylinder heads have passages for the coolant to pass through without getting into the oil or the combustion chamber. These passages are referred to as the “water jacket”.
While the coolant is passing through the water jacket, it absorbs heat from the engine on its way to the radiator for cooling. Between the engine and the radiator is a gatekeeper called the thermostat. The thermostat’s job is to regulate the temperature of the engine just like your home thermostat regulates the temperature of your house. It gets your engine up to the correct operating temperature and then keeps it from overheating.
When your first start the engine, it’s very cold and needs to warm up. So the thermostat blocks the flow of coolant to the radiator. As the engine warms up, the thermostat starts to let coolant flow through the system.
The final component I want to talk about is the overflow reservoir. This bottle is designed to hold some of the coolant. It’ll have a mark that indicates whether or not you have enough coolant. This is where you should add coolant if you just need to top it off.
Caution: never open the reservoir or the radiator cap when the car’s hot. The cooling system is pressurized and opening them while it’s hot can cause hot coolant and steam to escape resulting in serious burns.
Cooling system failure is the most common mechanical failure in vehicles around Bowie Maryland. Your Bowie Maryland service center can do a periodic inspection of the components for leaks, loose connections and weakening hoses.
Council of Automotive Repair
1532 Pointer Ridge Place Suite G
Bowie , Maryland 20716
800-492-0329
Your manufacturer has also specified a cooling system service interval. With a cooling system service, the old coolant is replaced with correct clean fluid that contains the additives required to prevent corrosion. The additives are depleted over time and you need fresh fluid for adequate protection. Your radiator pressure cap should be replaced at this service as well.
Today we want to talk about a very important system in our cars – the cooling system. It’s one of those things that you don’t give much thought to until it fails and then you’re stranded by the side of the road.
Cooling systems fail more often than any other mechanical system – usually because of neglect. Don’t you hate it when something breaks, and you could have done something to prevent it?
The good news is that if you take care of your cooling system it can keep working for the life of your car.
Here at AutoNetTV, we emphasize preventive maintenance services like replacing your coolant according to the factory schedule. But the various parts that make up the cooling system need attention too. The major components of the cooling system are the water pump, freeze plugs, the thermostat, the radiator, cooling fans, the heater core, the pressure cap, the overflow tank and the hoses.
It sounds complicated, but we don’t have to be experts – we can leave that to our honest service technicians at Council of Automotive Repair. But, having an overview will help us remember to take care of our cooling systems.
Most people would be surprised to know that burning fuel in your engine produces up to 4,500 degrees of heat. And all that heat has to be dealt with. If the heat can’t be drawn off the engine, the pistons will literally weld themselves to the inside of the cylinders – then you just have to throw the engine away and get a new one. That would cost thousands of dollars.
Now the water pump is what forces the coolant through passages in the engine to absorb heat. The pump is driven by a belt that needs replacement from time to time. And the water pump will eventually wear out and need to be replaced. Spending some money on replacing the belts and water pump is much less than the cost of repairing the massive damage that can be done when an engine seizes.
There’s another little part of the coolant system that protects the engine. It’s called a freeze plug. If you remember from high school chemistry, water expands when it freezes. In very cold areas, the coolant can actually freeze when the vehicle is left sitting.
It is hard to believe, but the expanding frozen coolant can actually crack the engine block. The freeze plugs fit into the engine block. They fit tight enough to withstand the pressure of a running engine, but can expand or pop out if the coolant freezes. These little things save a lot of engine blocks.
That brings up a good point. An engine has to work in all kinds of temperatures – extremely hot as well as very cold. How does the cooling system adapt to external temperatures as well as varying operating conditions?
Well, it’s much like the way you keep your house at a comfortable temperature all year round – with a thermostat. The thermostat in your car controls how much coolant flows through your engine. When the engine is cold, it restricts coolant flow until the engine comes up to an efficient operating temperature. Then it starts opening up to move more coolant to keep the temperature within a specified range.
The thermostat needs to be replaced from time to time as well. It’s easy to diagnose a failed thermostat and is fairly inexpensive to replace. We can do this for you at Council of Automotive Repair in Bowie , just give us a call: 800-492-0329. Now we’ve been talking about all this heat we’ve got to get rid of, but haven’t really talked about where it goes. That’s where the radiator comes in. The hot coolant passes through the radiator. Air flows past the cooling fins and cools the coolant.
The radiator has two tanks that hold coolant: sometimes one the top and bottom or one on either side. If you have an automatic transmission, one of the tanks will also contain a second tank that cools the transmission fluid. Large SUV’s and trucks often have a separate transmission cooler. So when you drive around Bowie , the air is forced past the radiator. But driving doesn’t produce enough air flow. So the radiator has cooling fans that force fresh air over the radiator. These fans may be powered by a belt or by electric motors.
Now, you also have something called a heater core. The heater core is like a mini radiator. A small fan blows air over the heater core and into the passenger compartment of your vehicle. That’s how you warm your car when it’s cold out.
Next is the radiator cap. With most newer cars around Bowie , you never remove the radiator cap, except to replace it. You add coolant through the overflow tank. The radiator cap is also called a pressure cap, because its job is to maintain pressure in the cooling system.
High pressure raises the boiling point of the coolant, so it cools more effectively even in very demanding conditions. That is why you need to replace the cap from time to time. They recommend changing it out every time you replace your coolant.
Coming back to the overflow tank, it is needed because when the coolant gets hot it expands and the overflow holds the extra volume. The tank helps maintain the proper level of coolant and keeps air out of the system. You should never open the radiator cap or over flow tank when the engine is hot. This could lead to serious burns.
What else do we need to do to keep our cooling systems working well? Well, there are the hoses that hook all of these pieces together. They’re obviously very tough to deal with the pressure and high temperatures. But they do get worn. Sometimes they get spongy from the heat. Sometimes they lose their connection to the radiator, water pump, etc. It’s a great idea to have your Bowie service center inspect your hoses at least once a year and replace them, if needed, before they break.
Council of Automotive Repair can help you check your cooling system and make any necessary adjustments or repairs. Give us a call at 800-492-0329.
The coolant system is a vital part of your vehicle. It is also the second most common cause for vehicle failures. Even though coolant system failure is fairly common, it is easy to prevent.
The most recognizable part of the coolant system is the radiator. It is connected to the engine with hoses and is filled with coolant. The coolant draws heat off the engine and then goes into the radiator. Air passes through cooling fins to reduce the temperature of the coolant and then it’s back to the engine again.
There are several ways for the cooling system to fail. Most common is with the coolant itself. Coolant is a mixture of water and antifreeze. The proper mixture keeps the coolant from either boiling away or freezing. Both of which can result in massive engine damage.
Another very important coolant issue that is often overlooked is the age of the coolant itself. antifreeze has additives that protect the coolant system from corrosion. As these additives are depleted over time, they can’t protect the radiator and other parts from rust, scaling and corrosion. Old coolant may still keep your engine cool, but it won’t protect it from corrosion.
If you see a warning message to check the coolant or if the temperature gauge is in the hot zone your cooling system needs to be checked. It’s OK to add water or antifreeze yourself. But you need to be cautious. Remember four things.
- First, you never want to open the radiator pressure cap. You could be severely burned.
- Second, try to get to a Bowie service center such as Council of Automotive Repair immediately if your coolant is low. If that is not possible, follow the directions in your owners manual – it will direct you to only make additions to the coolant overflow bottle.
- Third, remember that you need a proper mixture of water and antifreeze. If you make an emergency addition to your cooling system, follow-up with your service center where they can make necessary corrections.
- Fourth, not all cars use the same type of antifreeze. You need to check your owners manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. Again, another reason to rely on your Bowie service center to do things right.
Remember, Council of Automotive Repair has the equipment to change your coolant quickly and inexpensively. 800-492-0329
The coolant system is a vital part of your vehicle. It is also the second most common cause for vehicle failures. Even though coolant system failure is fairly common, it is easy to prevent.
The most recognizable part of the coolant system is the radiator. It is connected to the engine with hoses and is filled with coolant. The coolant draws heat off the engine and then goes into the radiator. Air passes through cooling fins to reduce the temperature of the coolant and then it’s back to the engine again.
There are several ways for the cooling system to fail. Most common is with the coolant itself. Coolant is a mixture of water and antifreeze. The proper mixture keeps the coolant from either boiling away or freezing. Both of which can result in massive engine damage.
Another very important coolant issue that is often overlooked is the age of the coolant itself. Antifreeze has additives that protect the coolant system from corrosion. As these additives are depleted over time, they can’t protect the radiator and other parts from rust, scaling and corrosion. Old coolant may still keep your engine cool, but it won’t protect it from corrosion.
If you see a warning message to check the coolant or if the temperature gauge is in the hot zone your cooling system needs to be checked. It’s OK to add water or antifreeze yourself. But you need to be cautious. Remember four things.
- First, you never want to open the radiator pressure cap. You could be severely burned.
- Second, try to get to a local service center immediately if your coolant is low. If that is not possible, follow the directions in your owners manual – it will direct you to only make additions to the coolant overflow bottle.
- Third, remember that you need a proper mixture of water and antifreeze. If you make an emergency addition to your cooling system, follow-up with your service center where they can make necessary corrections.
- Fourth, not all cars use the same type of antifreeze. You need to check your owners manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. Again, another reason to rely on your Bowie service center to do things right.
Remember, your local repair shop